Audi AUD-S Bedienungsanleitung

INSTALLATION AND OWNER’S MANUAL As of date of manufacture, meets all ANSI/UL 325 Safety Requirements for Vehicular door operators AUD-S AU SERIES WITH

TO AVOID DAMAGE TO DOOR AND OPERATOR ENSURE ALL DOOR LOCKS ARE DISABLED. USE AN INTERLOCK SWITCH IF A LOCK IS REQUIRED TO RETAIN FUNCTIONALITY. CAUT

Figure 15 OPENTB1STOPCLOSEOPENCOMCLOSESTOPNO REVNC REVPHOTOCOMSINGLEILOCK24 VACCOMSAFE FINISH PHOTOBEAM3-WIRE PHOTOBEAM MOTOR CONTROL BOARD Door Edge

12 NOTE: It is now necessary to turn on the power in order to change the Operating Mode (if applicable), program any changes desired to the operator’

OPERATION AND ADJUSTMENT INSTRUCTIONS 13 IMPORTANT SAFETY INSTRUCTIONS FOR OWNER • Understand all of the operating features of your door control syste

14 OPERATION AND ADJUSTMENT INSTRUCTIONS Changing the Switch Selectable Operation Modes The following modes are selected by setting the on-board dip s

OPERATION AND ADJUSTMENT INSTRUCTIONS 15 TS Operation Open Button: Momentary activation; open override of closing door. Close Button: Momentary activ

The solenoid operated brake may require occasional adjustment. Adjustment is necessary if door tends to drift downward after reaching the open limit.

remember to use the STOP button to stop the door at the Fully Open Position. 4) Depress the limit nut retaining plate (D) so it disengages from the s

CLUTCH ADJUSTMENT The clutch serves to protect the door, the electric operator and other equipment from undue stress or damage caused by starting forc

Following installation, the operator MUST be tested and respond correctly to all controls as specified on the wiring diagram. Keep personnel and equip

READ THESE STATEMENTS CAREFULLY AND FOLLOW THE INSTRUCTIONS CLOSELY. The Warning and Caution boxes throughout this manual are there to protect you

575 VOLTS, 3 PHASESINGLE VOLTAGE MOTORBL/BLKBL/BLKTO REVERSE MOTOR, SWITCH LEADS 1 & 3L14L2YELLOWWHITEBLACKORANGEBLUEREDWire Nut Connection3BLUE (

WIRING DIAGRAM/SCHEMATIC - THREE PHASE 21 575 VOLTS, 3 PHASESINGLE VOLTAGE MOTORBL/BLKBL/BLKTO REVERSE MOTOR, SWITCH LEADS 1 & 3L14L2YELLOWWHITEBL

FIGURE 24 - OPERATOR DIMENSIONS 107093 OPERATOR DIMENSIONS / NOTES 22 NOTES

Ref Part # Description Assemblies A 106798 Frame Assembly w/Shafts, AUD (1/3 HP) 107412 Frame Assembly w/Shafts, AUD (1/2 & 3/4 HP

Manufacturer’s Limited Warranty Linear LLC warrants its Allstar brand commercial door operators to be free from defect in material and workmanship fo

MODEL AUD-S OPERATOR APPLICATIONS: Drawbar operators are for commercial and industrial use on sectional overhead doors which use horizontal track wit

Before starting the installation of the operator, the door must be in good working condition and properly counterbalanced. Inspect the door and trac

TO REDUCE THE RISK OF SEVERE INJURY OR DEATH: READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS! WARNING ITEM # PART# DESCRIPTION QUAN.

2) After the track is assembled, position track assembly onto the operator power head and attach with four 3/8”-16 x 1” bolts, lock washers and nut

TO AVOID DAMAGE TO DOOR AND OPERATOR ENSURE ALL DOOR LOCKS ARE DISABLED. USE AN INTERLOCK SWITCH IF A LOCK IS REQUIRED TO RETAIN FUNCTIONALITY. CAUT

4) Mount the front mounting bracket (Item 9) to the mounting pad as shown in Figure 8. The location of the door’s torsion shaft may prevent you from

8) Figure 12 details a typical method of hanging the operator from the ceiling. Each installation will vary due to the difference in building struct